Glass Pocket Door Bathroom - Just a couple months back I went over to fix a pocket door that was shutting in a weird angle. This is the very first time I had ran into this sort of scenario and was undoubtedly confused. I got a torch and began looking in the pocket door frame. I had trouble discovering the issue but when I did it was evident.
The bottom of the door would stick out about an inch and a half passed the door jam as the pocket door was skidding shut it would work flawlessly but when you went to open it. The issue turned out to be the track was missing a screw in the very rear so that as the door slid back to the framework the tracking would hang down at an angle from the weight of the door. There is not any solution to reach the screw because it was at that very back of the pocket door frame close to the framing itself.
This is the only thing I could think of and would require a wall patch that is simple and a few paint to help make the repair whole. Then I use some quick setting drywall plaster and some fiberglass drywall tape to fix the wall. This took another hour in order to complete the drywall correctly.
Some pocket door difficulties are a little more easy to fix than this one. Most pocket doors seemed to have difficulties falling and eventually are left shut, never to be properly used again. Painting the doors over and over again can in fact increase the depth of the door or the door to swell preventing it from opening correctly can be also caused by excessive moisture in the house over long amounts of time.