Pocket Door Top Roller Hardware

70 views

Pocket Door Top Roller Hardware prime line pocket door top roller assembly 1 14 in nylon ball 1000 X 1000


Pocket Door Top Roller Hardware - Just a few months back I went over to repair a pocket door that was shutting at a bizarre angle. This was the first time I had ran into this type of situation and was undoubtedly lost. I began looking within the pocket door frame and got a flashlight. I had difficulty finding the problem but when I did it was clear.

The bottom of the door would stick out about an inch and a half, as the pocket door was slipping closed it would work flawlessly but when you went to open it. There clearly was not any strategy as it was at that back of the pocket door frame close to the framing itself to reach the screw.


As a way to repair the pocket door difficulty, I had been going to have to remove an excellent sized area of the plastered wall at the top right hand corner of the pocket door frame. This was the only thing I really could think of and would require a wall patch that is simple plus some paint to make the repair complete. This job took me to cut the hole and replaced the screw that had fallen out from the pocket door path. Then I use some fiberglass drywall tape and some fast setting drywall plaster to correct the wall. This took another hour in order to complete the drywall properly.

Some pocket door problems are a little easier to repair than this one. Most pocket doors appeared to have problems sliding and eventually are left closed, never to be properly used again. Painting the doors over and over again can in fact add to the depth of the door or excessive moisture in the house over long amounts of time also can make the door to swell preventing it from opening properly.

Tags: #pocket door top roller hardware