Hardware For Pocket Doors Baldwin - Just a couple of months back I went over to fix a pocket door that was shutting in a strange angle. This is the very first time I'd ran into this kind of situation and was undoubtedly confused. I got a torch and began looking within the pocket door frame. I had trouble discovering the issue but when I did it was clear.
As the pocket door was skidding shut it works flawlessly but when you went to open it the bottom of the door would stick out about an inch and a half. The problem turned out to be as the door slid back to the framework the tracking would hang down at an angle from the weight of the doorway and the course was missing a screw in the rear. There clearly was no strategy to reach the screw since it was at that back of the pocket door frame close to the framing itself.
This is the sole thing I really could think of and would require a wall patch that is simple plus some paint to help make the repair complete. This job took me about one hour to cut the hole and replaced the screw that had fallen from the pocket door track. Then I use some quick setting drywall plaster plus some fiberglass drywall tape to correct the wall. This took another hour to complete the drywall properly.
Some pocket door problems are a little more easy to fix than this one. Most pocket doors seemed to have problems sliding and eventually are left shut, never to be properly used again. Painting the doors over and over again can actually add to the depth of the door or excessive moisture in the home over long periods of time may also make the doorway to swell preventing it from opening properly.